How to send crypto from Trust Wallet to an exchanger

Key takeaways
- Trust Wallet labels each USDT by network under the ticker: TRC20 reads Tron, ERC20 reads Ethereum, BEP20 reads BNB Smart Chain.
- A TRC20 send needs roughly 15 TRX for the fee, about $1; with zero TRX the app refuses to send.
- Check the first four and last four characters of the pasted address against the order page before confirming.
Trust Wallet shows three or four different USDT lines and our order shows one address. Pick the wrong line and the transfer either fails at the fee step or goes to a ledger we do not see. Here is the send screen, step by step, with the checks that catch every mistake we have had to untangle.
Find the right USDT in the list
Open the wallet and look at the token list. Each USDT entry carries a small network label: Tron, Ethereum, BNB Smart Chain, Polygon. Our order page names one network next to the address. Tap the USDT whose label matches. If the matching one is missing, tap the toggle icon at the top of the list, search USDT and enable the right network. A common error is tapping the USDT with the largest balance, which may be on a different chain from the order.
Paste the address and read it twice
Tap Send, then paste the address copied from the order page. Never type it and never copy it from a chat, because clipboard malware exists that swaps addresses on paste. Compare the first four and last four characters with the order page. On Tron the address starts with T; on Ethereum and BNB Chain with 0x. If the wallet shows a warning that the address is invalid for this network, you picked the wrong USDT line; go back rather than trying another network.
The order matters more than it looks. Doing these two things in the wrong sequence is the difference between a locked rate and whatever the market gives you twenty minutes later.
Amount, fee, and who pays it
Enter the exact amount from the order. Trust Wallet shows the network fee under it: on Tron roughly 15 TRX, about $1; on Ethereum $4 to $14 in ETH; on BNB Chain under $0.50 in BNB. That fee comes from a separate balance of the network's own coin. If that balance is zero the app shows an insufficient fee message and stops. Buy a small amount of TRX, ETH or BNB first; we sell all three in amounts as small as $5.
| Route | Cost | Settlement | Who you trust |
|---|---|---|---|
| Bank card | shown in the order | depends on the issuing bank | Exchanger and issuing bank |
| Bank transfer | shown in the order | follows banking days | Two banks and a compliance officer |
| P2P on an exchange | set by the seller | minutes to hours | A stranger and an escrow |
The confirmation screen
Before the final tap the app shows a summary: asset, network, recipient, amount, fee. Read all five lines. The asset should say USDT, the network should match the order, the recipient should match the first and last characters you checked, the amount should be what the order expects. Memo or tag fields are not needed for our addresses; leave them empty. Tap confirm, enter the wallet PIN or use the fingerprint, and the transaction is broadcast.
After sending: hash, tracking, and stuck states
The wallet shows the transaction with a status. Tap it to see the hash; copy it and keep it, because it is the reference for support. On Tron the order page updates within a minute, on Ethereum within three. If the wallet says pending for more than ten minutes on Ethereum, gas was set too low; you can speed it up from the transaction screen. If the order page does not update after the wallet says completed, send the hash to support and we locate it on the network.