Exchange USDT (TRC20) to ERC20
The same token moved from Tron to Ethereum.
Pick what you send and what you receive.
500 USDT − fee 3 USDT (0.6%) = 497 USDT
Start exchangeNothing is charged until you send the funds yourself. Identification follows the AML policy.
Worked example
Send 500 USDT at the example rate of 1 USDT = 1 USDT: that is 500 USDT before our fee. The fee of 0.6% is 3 USDT, so about 497 USDT is paid out.
Amounts at a glance
| You send | You receive |
|---|---|
| 100 USDT | 99.4 USDT |
| 500 USDT | 497 USDT |
| 1,000 USDT | 994 USDT |
| 5,000 USDT | 4,970 USDT |
Indicative, at the example rate and after our fee.
Three steps
Create the order
Enter how much USDT to give for USDT and press Start exchange. Registration and identification come first.
Send USDT
Send the USDT on TRC20 only, to the address in the order.
Receive USDT
We pay the USDT on ERC20 once your USDT is confirmed.
What it costs in full
| What | On 500 USDT |
|---|---|
| Our fee (0.6%) | 3 USDT |
| Network fee on TRC20, paid by you | about $1 |
| You receive about | 497 USDT |
Our fee here is 0.6%, against 0.3% to 1.2% across the 20 ready directions with USDT. The minimum of 100 USDT is about $100 at the indicative price. By fee it stands 12th of 20 for USDT, and USDT sits in 1 ready direction of its own.
Fee is 0.6%; on a 1,000 USDT trade that's 6 USDT for moving value from one network to the other. The TRC20 deposit costs about 1 USDT. Sending USDT on Ethereum costs 4 to 14 USD in gas -- on a 1,000 USDT trade that can equal the entire commission on a bad gas day. This is essentially a network-swap service, so payout gas matters more here than on most routes.
Bringing USDT and receiving USDT
Send USDT on TRC20 only. The USDT arrives on ERC20: 12 confirmations, usually three to five minutes. Ethereum charges by network load, so the same transfer costs four dollars at night and fourteen at peak. Check the network label next to the address before you confirm.
What to watch here
- Both sides of this order are literally called USDT, which is exactly the trap, the single most common mistake here is depositing on the wrong chain because the name never changes even though the network does. Send over TRC20, confirm the receiving address is explicitly the Ethereum version before sending.
- The token is the same on both sides and the networks are different. An address on ERC20 does not read a transfer sent on TRC20, so check the network label next to the address before you send.
- Compare the price of the two networks: TRC20 costs about $1 to move and ERC20 costs $4 to $14. On a small amount the network fee can be larger than ours.
- This is a change of network, not of currency: you pay our fee for the move and the Ethereum fee later, whenever you use the coins. To only hold USDT, the Tron version is cheaper to keep.
- The dollar value stays the same and only the network changes, but technically the coins you send and the coins you receive are separate tokens. You pay for the move, so the amount that arrives is a little smaller than the one you sent.
- Check both labels in the order. The sending side and the receiving side name different networks, and each wallet must be on its own.
- Before you start, write down which wallet will hold the coins at the end. A wallet app that supports one of the two networks and not the other is the usual reason a swap has to be redone.
- Minimum for USDT to USDT: 100 USDT.
Verification before the first exchange
Every client is checked once, before the first exchange: a passport or an ID card, the same for USDT to USDT and for every other direction. Above $50,000 an order also needs a source-of-funds document. See the verification page.
Other ways to do this
A cross-chain bridge or an exchange that lists both versions lets you move TRC20 USDT to Ethereum-native USDT yourself, and for someone comfortable with bridge interfaces and willing to pay bridge fees plus ERC20 gas, that's a viable DIY path. It's also the step where people lose funds most often on their first try, sending to a bridge contract without approving the right token or picking the wrong destination chain. Ordering the conversion here as one transaction removes that failure point entirely.
